Simrad EK15 - System Setup and Software Installation Procedures; Initial Transceiver Setup

SimradEK15
Systemsetupandsoftwareinstallation
procedures
Theseproceduresexplainhowtoinstallafrequencychannel,andhowtomodifythe
IPaddressifidenticaltransceiversareused.Proceduresforsoftwareinstallationare
alsoprovided.
Topics
•Initialtransceiversetuponpage80
•Installingafrequencychannelonpage81
•Disconnectingafrequencychannelonpage82
•ModifyingatransceiverIPaddressonpage82
•Updatingtheon-linehelponpage84
•Softwareinstallationproceduresonpage86
–InstallationoftheEK15softwareonpage86
–UpgradingtheEK15softwareonpage87
–RemovingtheEK15softwarefromtheProcessorUnitcomputeronpage87
Initialtransceiversetup
Purpose
Thisprocedureexplainshowtosetupyoucomputertocommunicatewiththetransceiver.
Youonlyneedtodothisonce.
Relatedtopics
•Installingafrequencychannelonpage81
Procedure
1Onthecomputer,denethenetworkadaptersettings.
Windows
®
7
aClickStart→ControlPanel→NetworkConnections.
bClickChangeadaptersettingsontheleftmenu.
cClickonceonthenetworkadaptertoselectit,andclickPropertiesonthe
short-cutmenu.
dOnthelistofconnections,clickInternetProtocol4(TCP/IPv4),andthen
Properties.
eClickUsethefollowingIPaddress,andentertheIPaddressandnetworkmask.
IPAddress:157.237.14.60
Subnetmask:255.255.255.0
fClickOKtosavethesettings.
gExitalldialogboxes.
2Onthecomputer,starttheEK15program.
80
351718/C