FDT2
5: Reverse running (REV)
6: Jogging
7: Inverter Fault
8: Inverter Ready
9: Upper Limit Frequency Reach
10: Lower Limit Frequency Reach
11: Current Limit Enabled
12: Overvoltage Stall Enabled
13: Simple PLC Cycle Finished
14: Set Count Value Reach
15: Designated Count Value Reach
16: Length Reach
17: Motor Overload Pre-alarming
18: Inverter Overheating Pre-Alarming
19: PID Feedback Upper Limit Reach
20: PID Feedback Lower Limit Reach
21: Analog input Level Detection ADT1
22: Analog input Level Detection ADT2
23: Not Used
24: Undervoltage Status
25: Motor Overheating Pre-alarming
26: Set Time Reach
27: Run at Zero Speed
28~48: Not Used
38: Off Loading
49: Inlet Valve Control
50: Fan Start-stop Control Signals
51: Phase Angle Arrival
52: Inverter Startup Is Completed
53: Switch to Power frequency
54~55: Not Used
56: Pipeline Overpressure Alarm
57: Under-voltage Alarm
58: Water Shortage Alarm
59: Dormancy Instructions
60: Pump Rotation Instructions
61: The Standby Pressure Operation
Instructions
62: Not Used
63: H Pump Control
To Next Page
Loading...
