OnAir 3000 Digital Mixing Console
5-48 Operation
Document generated: 10.10.14
SW V6.0
5.3.4.4 CR/ST 1 CUE Pages
Since SW V3.2, this page has been split up into a CUE and an MPX part; the
CUE part is shown above, the MPX part below. MPX conferencing features
are available only if the MPX option is installed.
N–X 1 - 48 Selects which buses will be conference members. If an N–X bus is selected, all
contributors to this bus will be conference members automatically. Depending
on the DSP configuration, not all 48 N–X buses might be available.
CUE These keys send predefined CUE feeds to the corresponding N–X bus (this
feature is available without MPX option as well).
 CR MON Selects the signal that has been selected for CR monitoring as a CUE signal
(corresponds to the ‘Follow CR’ function on other monitoring pages).
Cue Source Buttons These buttons select the source that is fed as the cue signal. The 10 sources
displayed on these buttons are predefined during system configuration (in the
DeskCommon - Cue Keys page).
To Next Page
Loading...
Need help?
General
