TECO A510s - Page 184

4-106
Example: Set 00-03 (alternative run command source selection) to be different from the default value.
Steps LCD Display Descriptions
1
The starting parameter group (00) in the setting modes of ▲ (Up)/
▼ (Down) selection groups.
2
PARA 00
-01. Motor Direction
-02. RUN Source
-03. Sub RUN Source
Press READ/ ENTER key and ▲ (Up)/ ▼ (Down) to select
alternative run command source (00-03).
3
Edit 00-00
Sub RUN Sou ce
1 Terminal
(0 ~4)
<2>
Press READ/ ENTER key and adjust the value. The selected setting
value will flash.
4
PARA 00
-33. Modify parameter
-41. User P1
-42. User P2
Press DSP/ FUN to the menu of modified parameters (00-33).
5
Edit 00-33
Modify parameter
1 Enable
(0 ~1)
<0>
Press READ/ ENTER key to adjust the value to 1 (The modified
parameter is enabled.) The selected setting value will flash.
6
Modify 00
00-03. Sub RUN Source
00-33. Modify parameter
Press DSP/ FUN back to the advanced modes.
Group
00 Basic Func.
01 V/F Pattern
02 Motor Parameter