TECO A510s - Operation Control Function; Input from the Ladder Program; Input from Function Program

4-327
4: Operation control function
Symbol Description

Forward /Reversal control can be set by ( I1~f8 )
OFF: Forward(FWD)
ON: Reversal(REV)

Speed terminal control can be set by ( I1~f8 )
OFF: Operation based on  set frequency
ON: Operation based on frequency of speed 

Set frequency (can be constant or V3、V4，V5 )

Speed frequency (can be constant or V3、V4，V5)

Acceleration time (ACC Time)

Deceleration time (DEC Time)
 Operation command output (F1 to F8, there are a total of 8 operation control functions)
Example:
F1
F1
I1
Q1
RUN/STOP of F1 is determined by
ON/OFF of I1
10.00
10.00
60.0
30.0
F1
M1
M2
F1 is ON inverter starts running
and at the same time, the F1 input of the
ladder program is ON as well.
Input from Function Program
Input from the Ladder Program
n
n