TECO A510s - Photo-Coupler Output; Photo-Coupler Output Selection

4-161
Terminal S1
Terminal S2
ON ON ON
Hz
T
△Hz
Output
Frequency
ON ON ON
Lower
Limit of
Frequency
Reference
Upper
Limit of
Frequency
Reference
Mode 3: When 03-40 is not set to 0 Hz and terminals conduction time > 2 Sec, frequency changes upon general
acceleration/ deceleration.
Terminal S1
Terminal S2
ON
2Sec
OFF
OFF
ON
2Sec
T
Hz
Upper
Limit of
Frequency
Reference
Output
Frequency
DH1
t1
DH2
t2
△Hz
Lower
Limit of
Frequency
Reference
※Descriptions:
ᇞH1: frequency increment setting at acceleration, t1: terminal conduction time at acceleration,
ᇞH2: frequency increment setting at deceleration, t2: terminal conduction time at deceleration.
(t1) Time Conduction Terminal
2 Time onAccelerati
Frequency Limit Upper
∆H1 
(t2) Time Conduction Terminal
2 Time onDecelerati
Frequency Limit Lower
∆H2 
03- 28 Photo-coupler Output
Range
See function selection list parameter 03-11
03-29
Photo-coupler Output Selection
Range
xxx0b: Photo-coupler A Contact xxx1b: Photo-coupler B Contact
0 = Normally open (A), 1 = Normally closed (B)