TECO A510s - Main Circuit Terminal Wiring; Closed-Loop Crimp Terminal Size

B-4
 Main Circuit Terminal Wiring
UL approval requires crimp terminals when wiring the inverter’s main circuit terminals. Use crimping tools
as specified by the crimp terminal manufacturer. Teco recommends crimp terminals made by NICHIFU for
the insulation cap.
The table below matches inverter models with crimp terminals and insulation caps. Orders can be placed
with a Teco representative or directly with the Teco sales department.
Closed-Loop Crimp Terminal Size

Type 1
During installation, all conduit hole plugs shall be removed, and all conduit holes shall be used.
Note: Contact Teco for inverter ratings 2125-2150 and 4250- 4425.