TECO A510s - JN5-PG-L Speed Feedback Card

11-15
B) JN5-PG-L speed feedback card: Line driver speed feedback card
JN5-PG-L terminal specification
Terminal Name Description
Vcc
Power supply for encoder.
12V or 5V ±5%, 200mA Maximum
(12V or 5V input voltage selected by the Switch Jumper. Can’t
use both 12V and 5V at the same time)
GND (0V Common Terminal)
A, /A, B, /B, Z, /Z
Encoder input signal, A correct divider ratio output requires a
two-phase input. Line driver input type, RS-422 level input.
AO, /AO, BO, /BO, ZO, /ZO
A ,B phase divider ratio output, z phase output monitor,
Line driver output type, RS-422 level output.
E
Grounding terminal.
JN5-PG-L block diagram: