TECO A510s - Copy Keypad Parameters to the Inverter

4-268
 WRITE: Copy Keypad parameters to the Inverter
Steps LCD Display (English) Description
1
Select the copy function group (16) from the group menu.
2
Press the Read / Enter key and select parameter (16-07) copy
sel.
3
Press the Read / Enter key to display the data setting / read
screen (LCD display is inversed).
4
Change the set value to 2 (write) by using the up arrow key.
5
 Use Read / Enter key to enable the read operation, the
display is shown as the left.
 The bottom of LCD display will show a bar to indicate the
read progress.
6
-ADV-
WRITE
COMPLETE
“WRITE COMPLETE” will be displayed on the keypad when
writing was successful.
 The error message of “WRE Write Error " may occur on the
keypad when writing parameters to the inverter is prohibited.
 If the error is displayed, press any key to remove the error
message and go back to parameter 16-07.
7
When DSP/FUN key is pressed, the display returns to
parameter 16-07.