。
Adjusting motor slip will change the rotor resistance parameter. The motor slip is adjusted depending on the
motor performance.
02-37 Motor Mechanical Loss
Range
0.0~10.0 %
Adjustment range of mechanical loss is 0.0~10.0%. It is enabled only in the speed mode and the speed command
being 0.
If the speed command is 0 and the shaft will be at slow drift causing to be static incompletely, adjust upwards the
range of mechanical loss until the shaft is completely static.
Note: After executing auto-tuning, parameters which marked <1> will renew the value. Please refer Group 17: Automatic
Tuning Parameters for more detail.
To Next Page
Loading...
