TECO A510s - Monitoring Parameters

4-56
Group 11: Auxiliary Parameters
Code Parameter Name Setting Range Default Unit
Control mode
Attribute
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
SLV2
Preventing
Oscillation
11-61
Time Parameter o
f
Preventing
Oscillation
0~100 0 O O X X X X O
11-62
Selection of
Preventing
Oscillation
0: Mode1
1 O O X X X X O
1: Mode2
11-63
Strong Magnetic
Selection
0: Disable
1 X X O O X X X
1: Enable
11-64
Acceleration
Speed Gain
Adjustment
0.1~10.0 1.0 - O X X X X X O
11-65
Target Main
Circuit Voltage
200V: 200V~400V 370
- O X X X X X O
400V: 400V~800V 740
575V: 520V~1040V 962
690V: 624V~1248V 1154
*: Refer to the attachment 1.
** If the maximum output frequency of motor is over 300HZ,the frequency resolution is changed to 0.1Hz
Group 12: Monitoring Parameters
Code Parameter Name Setting Range Default Unit
Control mode
Attribute
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
SLV2
12-00
Display Screen
Selection (LED)
00000~77777
From the leftmost bit, it
displays the screen when
press DSP key in order.
0:no display
1: Output Current
2: Output Voltage
3: DC Bus Voltage
4: Heatsink Temperature*
5: PID Feedback
6: AI1 Value
7: AI2 Value
00000 - O O O O O O O
*1
*6
12-01
PID Feedback
Display Mode
(LED)
0: Display the Feedback
Value by Integer (xxx)
0 O O O O O O O *6
1: Display the Feedback
Value by the Value with
One Decimal Place
(xx.x)
2: Display the Feedback
Value by the Value with
Two Decimal Places
(x.xx)