TECO A510s - PG Speed Feedback Card; JN5-PG-O Speed Feedback Card; JN5-PG-O Block Diagram

11-14
11.5 PG Speed Feedback Card
Refer to specified instruction manual for installation of each option card.
JN5-PG-O
JN5-PG-L
JN5-PG-PM
JN5-PG-PMR
Wiring Size
24~16 AWG
(0.205~1.31mm
2
)
Torque
TB1 0.22~0.25 N.M
TB2 0.2 N.M
Refer to the dedicated option card manual for installation instructions.
A) JN5-PG-O speed feedback card: Open collector speed feedback card
JN5-PG-O terminal specification:
Terminal Name Description
Vcc
Power supply for encoder.
12V or 5V ±5%, 200mA Maximum
(12V or 5V input voltage selected by the Switch Jumper. Can’t
use both 12V and 5V at the same time)
GND (0V Common Terminal)
A, /A, B, /B, Z, /Z
Encoder input signal, two-phase input is required for correct
divider ratio output. Open collector input type.
AO, /AO, BO, /BO, ZO, /ZO
A ,B phase divider ratio output, z phase output monitor,
Open collector type: 24V, 30mA.
E
Grounding Terminal.
JN5-PG-O block diagram: