TECO A510s - Function Setting of Pulse Input; Scale of Pulse Input

4-162
03- 30 Function setting of pulse input
Range
0: General Pulse Input
1: PWM
There are two ways for pulse input selection:
(1) General pulse input:
PI= cutoff frequency divided by pulse input scale set by 03-31, corresponding to the maximum output
frequency of motor 1 (01-02).
Monitoring parameter 12-79 (pulse input percentage) is the proportional relationship between input signal and
pulse input scale of 03-31.
(2) PWM: It is required to input the correct frequency.
PWM= Time of negative edge pulse divided by the time period of pulse, corresponding to the maximum output
frequency of motor 1 (01-02).
Monitoring parameter 12-79 (pulse input percentage) is the proportional relationship between the negative
edge terminal of input signal and time period.
Note: Deviation of pulse time period in PWM is ±12.5%. If it is over the deviation range, pulse input is not active.
Diagram for pulse input selection:
03-31
Scale of pulse input
Range
Depending on the setting of 03-30
03-30=0: 50~32000Hz
03-30=1: 10~1000Hz