TECO A510s - JN5-PG-PM Terminal Specification; JN5-PG-PM Block Diagram

11-16
C) JN5-PG-PM speed feedback card: synchronous motor line driver speed feedback
card
JN5-PG-PM terminal specification
Terminal Name Description
Vcc
Power supply for encoder.
5V ±5%, 200mA Maximum
GND (0V Common Terminal)
A, /A, B, /B, Z, /Z
U, /U, V, /V, Z, /Z
Encoder input signal, A correct divider ratio output requires a
two-phase input.
Line driver input type, RS-422 level input.
AO, /AO, BO, /BO, ZO, /ZO
A ,B phase divider ratio output, z phase output monitor,
Line driver output type, RS-422 level output.
E
Grounding terminal.
JN5-PG-PM block diagram: