TECO A510s - Copy Inverter Parameters to the Keypad

4-267
■ READ: Copy inverter parameters to the keypad
Steps Keypad (English) Description
1
Select the copy function group (16) from the group menu.
2
Press the Read / Enter key and select parameter (16-07) copy sel.
3
Press the Read / Enter key to display the data setting / read screen
(LCD display is inversed).
4
Change the set value to 1 (read) by using the up arrow key.
5
 Use Read / Enter key to enable the read operation, the display is
shown as the left.
 The bottom of LCD display will show a bar to indicate the read
progress.
6
-ADV-
READ
COMPLETE
“READ COMPLETE” will be displayed on the keypad when reading
was successful.
 The error message of "RDP Read Prohibited" may occur on the
keypad when reading parameters from the inverter is prohibited.
 If the error is displayed, press any key to remove the error
message and go back to parameter 16-07.
7
When DSP/FUN key is pressed, the display returns to parameter
16-07.