4-104
00-32=6: Hoist* Consult TECO for the detailed settings
Parameter Name Value
00-00 Control mode selection 2: SLV
00-05 Main Frequency command source selection 0: keypad
11-43 Hold Frequency at start 3.0 Hz
11-44 Frequency hold Time at start 0.3 sec
00-14 Acceleration time 1 3.0 sec
00-15 Deceleration time 1 3.0 sec
11-01 Carrier frequency 5.0kHz
05-01 Frequency setting of speed-stage 0 6.0 Hz
05-02 Frequency setting of speed-stage 1 30.0 Hz
05-03 Frequency setting of speed-stage 2 60.0 Hz
03-28 Photo-coupler output 5 : frequency detection 2
07-18 Minimum baseblock time 0.3 sec
08-00 Stall prevention function
xx1x: Stall prevention ineffective in
deceleration
03-13 Frequency detection level 2.0 Hz
03-14 Frequency detection width 0.0 Hz
08-18 Selection of low-torque operation 0: Deceleration to stop
08-19 Level of low-torque detection 2 %
08-20 Time of low-torque detection 0.5 sec
08-09 Selection of input phase loss protection 1 : Enable
08-10 Selection of output phase loss protection 1 : Enable
To Next Page
Loading...
