2-7
IM 701210-05E
Explanation of Functions
2
2.2 Setting the Horizontal and Vertical Axes
Zooming in or out of the Vertical Axis (Expand/Reduce) <Sections 5.8 and 5.9>
Zooming in or out by Setting the Magnification
The waveform display can be expanded/reduced vertically by a factor in the range ×0.1
to ×100 (×0.25 to ×100 for 50 V/div, ×0.5 to ×100 for 100 V/div, ×1 to ×100 for 200 V/div
on the 701260 (HV (with RMS)); ×0.5 to ×50 when measuring acceleration on the
701275 (ACCL/VOLT); and ×0.33 to ×100 on the 701280(FREQ)). The waveform
display can be zoomed around the vertical position. The waveform display can be
zoomed around the vertical position.
1 div=0.5 V
1 div=1 V
If V ZOOM is set to ×2
Vertical
position
mark
GND mark
Zooming Vertically According to the Upper and Lower Limits of the Display Range
You can zoom in on the desired section of the observed waveform by specifying the
upper and lower limits of the vertical axis to change the display range to a narrower
range for each displayed waveform. Conversely, you can widen the display range to
view waveforms outside the display range.
Zoom
+10 V
–10 V
+6 V
+2 V
+4 V
To Next Page
Loading...
Need help?
General
