13-3
IM 701210-06E
Saving and Loading Data
13
Procedure When the Zip Disk Cannot Be Ejected
If the Zip disk cannot be removed by performing the steps above, carry out the following
steps to remove it.
Insert a pin of approx. 1 mm in diameter into the eject button hole and press slowly. This
will cause the Zip disk to be ejected.
Eject button of the Zip dis
Insert a pin.
Zip disk eject hole
CAUTION
• Removing the Zip disk while the access indicator is ON may destroy the data on
the Zip disk.
• Do not use the Zip drive if the DL750 is installed using the stand. (For the
installation position, see section 3.2.)
• When turning ON/OFF the DL750, have the Zip disk removed from the drive.
• Do not insert the Zip disk into the drive, or remove the Zip disk from the drive
while the DL750 is starting up after turning ON the power (see section 3.4,
“Power Up Operation”). Doing so can damage the disk.
• The access indicator illuminates immediately after the Zip disk is inserted. Do
not operate the DL750 while the access indicator is illuminated. Such act can
lead to erroneous operation.
General Handling Precautions of Zip Disks
For the general handling precautions of the Zip disk, read the instruction manual that
came with the Zip drive.
13.1 Floppy Disks/Zip Disks/PC Cards
To Next Page
Loading...
Need help?
General
