To Next Page

To Previous Page

16-40

IM 701210-06E

Measurement Range

You can set the range on the time axis for measuring the waveform parameter.

Range1 and Range2 are the start and end points, respectively.

Selectable range: ±5 div

Resolution: Varies depending on the record length.

However, the measurement start point cannot be set to the same point as the

measurement end point or to a value to the right of the measurement end point.

Turning ON/OFF the Statistics Display

• The statistics (Max, Min, and Average) of the waveform parameters retrieved

into the PC can be displayed.

• To display the statistics, select the Statistics check box. Clear the check box to

not display the statistics.

• The number of measurement values displayed in the cell of Excel is up to the

number specified in “Number of Displayed Measured Values (Data Number)” on

the previous page. The statistics are determined on all the measured data since

the trend display was started, not on only the displayed measured values.

Updating the Setup Condition

Click Update to update the Marker Position and Range that are set on the control

Panel of the measurement trend window to match the newest setup conditions of

the DL750/DL750P.

• Starting/Stopping the Trend Display of the Measured Values of the Waveform

Parameters

Start

Click Start/Stop. The indicator illuminates in yellow, and retrieval of the measured

values of waveform parameters starts at the specified retrieve interval. At the same

time, Microsoft Excel starts, and the measured values and trend graphs are displayed/

drawn. If the statistical display is turned ON, the statistics are also displayed. The

retrieval of the measured value of waveform parameter continues until the operation is

stopped.

Stop

• Click Start/Stop while the trend display is in progress. The indicator turns OFF,

and the display and drawing of the measured values and trend graph stop.

• If you attempt to save the data to a file or close Excel while the trend display is in

progress, a runtime error occurs. In this case, select No on the runtime error

dialog box and close the dialog box. Then, click Start/Stop on the measurement

trend window to stop the trend display. After stopping the trend display, save the

file or close Excel.

16.7 Using the Web Server Function

YOKOGAWA DL750 User Manual

Questions and Answers: