Comen N10 - Page 268

System Alarm Messages
III-2
Vent Rhythm
Med
Pauses/min Too High
Med
VT>2
Low
Heart Pause
Low
Pacer Not Capture
Prompt
Pacer Not Pacing
Prompt
Missed Beats
Prompt
Couplet
Prompt
PVC
Prompt
A-Fib
Prompt
Irr Rhythm
Prompt
Irr Rhythm End
Prompt
A-Fib End
Prompt
1.3) ECG Physiological Alarm
Alarm Message
Alarm Level
Cause
Solution
ST-Single Change Larger
Med
ST-single change exceeds the
alarm limit
Check the patient's condition
and confirm that the patient type
and alarm limits are appropriate
to the patient.
ST-Dual Change Larger
Med
ST-dual change exceeds the
alarm limits
QTc Too High
Med
QTc exceeds the alarm upper
limit
ΔQTc Too High
Med
ΔQTc exceeds the alarm
upper limit
1.4) Resp Physiological Alarm
Alarm Message
Alarm Level
Cause
Solution
No Breath
High
The patient has no breath or
the patient’s respiratory
signal is too weak to be
analyzed by the system.
Check the patient’s condition.
Check whether the electrode is
placed correctly and the
electrode, power cables and lead
wires are firmly connected.
RESP Artifact
High
The patient's respiratory rate
cannot be measured due to
disturbance by the heartbeat.
Check the patient’s condition
and the connection of
electrodes, power cables and
lead wires.