320 Upgrade and Maintenance Manual
RX2520 M4
Ê If applicable, connect the cables of the ODD:
– ODD power cable to connector X17 on the backplane, see section
"Connecting a 2.5-inch HDD backplane" on page 143.
– ODD SATA cable to connector SATA ODD on the system board.
Ê If applicable, install the expansion card in slot 4, see section "Installing
expansion cards" on page 207.
Ê If applicable, connect the cables to the LTO drive, see section "Connecting
the LTO-drive" on page 292.
Ê If applicable, connect the cables to the RDX drive, see section "Connecting
the RDX-drive" on page 304.
I For the cable plan, see chapter "Appendix B" on page 411.
Ê Carefully pull the front panel module into its bay and regard that the locking
mechanism snaps in (see circle and figure 221 / 222).
V CAUTION!
Ensure that none of the cables are strained or damaged.
I The locking mechanism differs for the installations with LTO drives
because the drive need more place, so that an other locking recess point
is needed.
To Next Page
Loading...
