HP LaserJet Enterprise M552 - Page 224

Table 2-33 General Settings menu (continued)
First level Second level Third level Fourth level Values Description
Print Quality
(continued)
Transfer control Normal*
Alternate 1
Alternate 2 (M552/M553)
Alternate 3 (M552/M553)
Use this setting to
correct transfer issues
in print jobs. Turn this
feature on if green,
mottled images are
printed on the page.
Note that using this
mode can increase
problems with blurry
images or specks of
toner on the leading or
trailing edge of the
paper. The Alternate 1
setting reduces the T1
bias and should be
used when re-transfer
occurs. The Alternate
2 setting increases the
inter-page gap. Using
this setting reduces
throughput and might
decrease the print-
cartridge life. The
Alternate 3 setting
applies the Alternate 1
setting and the
Alternate 2 setting at
the same time. Use
this setting if the rst
two settings do not
correct the problem.
Fuser Temp (M552/
M553)
Normal*
Alternate
If the page shows a
faint image of the
page repeated at the
bottom of the page or
on the following page,
rst make sure the
Adjust Paper Types
setting and the Print
Mode setting are
correct for the type of
paper used. If ghost
images continue to
appear on the print
jobs, set the Fuser
Temp feature to the
Alternate setting.
Restore Optimize Use to return all the
settings in the
Optimize menu to the
factory-default values.
Resolution Image Ret 3600
1200dpi x 1200dpi
Sets the resolution at
which the printer
prints.
196 Chapter 2 Solve problems ENWW