Mitsubishi Electric Q12DCCPU-V - Page 464

15 - 10
15.2 Setting Parameters Added for Multiple CPU Systems
15.2.3 When creating a new system
15
STARTING A MULTIPLE CPU SYSTEM
Figure 15.5 Parameter setting procedure for creating a new multiple CPU system
(From the previous page)
Control CPU (setting required)
Set parameters other than these multiple
CPU system parameters.
Save the set parameters into a file.
End
In the Type column in the <<I/O assignment settings>> tab,
select "CPU (Empty)" for a slot where no module is mounted.
Click the Detailed settings button to open the Detailed
settings screen.
"Communication area setting (refresh setting)" in the
<<Multiple CPU settings>> tab (optional)
Set the points of the auto refresh area for the data to be
sent and received by auto refresh between CPUs.
Select a control CPU (No.1 to No.4) for each slot.
This setting is not available for intelligent function
modules of function version A.