Oki IP-6620 - 5.4.4 Media wrinkles check; 5.4.5 The bidirectional print position has not been adjusted

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
5-56
5.4.4 Media wrinkles check
<Description>
After the media has been installed, it has not been fed for four hours and 10 minutes.
<Action>
Raise the pressure roller lever, or execute FEED MEDIA or BACK FEED MEDIA.
If the warning does not disappear, perform the same actions as in 5.4.1 Cap open warning.
5.4.5 The bidirectional print position has not been adjusted
<Description>
You have not set the bidirectional position adjustment value in the media preset menu after you
installed the media, or after you chose for the first time a media preset for a new media.
<Action>
You have not set the bidirectional position adjustment value in the media preset menu after:
- You installed the media; or
- You chose for the first time a media preset for a new media.
If the warning does not disappear, perform the same actions as in 5.4.1 Cap open warning.
ADJUST BIDIRECTIONAL
PRINT POSITION
CHECK MEDIA
FOR WRINKLES