Oki IP-6620 - Menu tree

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
5-104
5.5.23 System Error 1e00: Cap Correction Value Error
<Description>
The correction value of the cap position is 0 (not corrected).
(The correction value of the cap position must be a value other than 0.)
<Faulty part>
(1) IC(EEPROM）
(2) PCB-ASSY-IPB5-100
<Action>
Restart the printer.
Check the Items to be Checked on the table below, and perform the actions starting from the top
until the problem is solved.
No
Items to be Checked
Action
1
Cap position correction value
Start the printer in the ignore fatal error mode (see Section
3.5.4). Perform the procedure in 7.4 Correcting the Cap
Position, and apply a value other than 0 as the correction
value.
2
EEPROM
Replace the EEPROM (see 5.9.2).
3
PCB-ASSY-IPB5-100
Replace the PCB-ASSY-IPB5-100.