Oki IP-6620 - 6.10.3 TORQUE-LIMITER

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 6 Parts Replacement (Disassembly/Reassembly)
6-95
6.10.3 TORQUE-LIMITER
<Removal>
1. Move the carriage to the maintenance
area.
2. Remove the CAPPING-UNIT-MW (see
6.10.1).
3. While paying attention not to remove the
GEAR(IDLER), remove the
BRACKET(GEAR-HV) with three
securing screws.
4. Remove the torque limiter shaft.
Note
Pay attention not to lose the shaft bearing 3A,
as the torque limiter shaft must enter in the
shaft bearing 3A.
5. Remove the gear (E).
6. Remove the E-ring.
7. Remove the GEAR(TL-HV)
8. Remove the torque limiter.
Note
Pay attention not to lose the parallel pin, as
the torque limiter is fixed with the parallel pin.
Gear (E)
GEAR(TL-HV)
E-ring
Torque limiter
Parallel pin
Torque limiter shaft
Shaft bearing 3A
BRACKET(GEAR-HV)