Oki IP-6620 - 6.3.15 CASE(CUTTER) and SLIDER(CUTTER)

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 6 Parts Replacement (Disassembly/Reassembly)
6-17
6.3.15 CASE(CUTTER) and SLIDER(CUTTER)
<Removal>
1. Grab the levers on both sides of the
CASE(CUTTER), and remove the
CASE(CUTTER) from the
SLIDER(CUTTER).
2. Remove the FRAME(CUTTER)MW with
four fixing screws (two screws on each
side).
3. From the FRAME(CUTTER)MW, remove
the POM spacer and one fixing screw.
Note
One POM spacer is fixed on the printer's right
and left (total of two), and either of the two will
be removed. The right figure shows the POM
space with one fixing screw taking the
right-side ones as example.
4. Slide the SLIDER(CUTTER) to remove it
from the FRAME(CUTTER)MW.
SLIDER(CUTTER)
CASE(CUTTER)
Lever
FRAME(CUTTER)MW
POM spacer
SLIDER(CUTTER)
FRAME(CUTTER)MW