Oki IP-6620 - When not using the printer for more than 2 weeks

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 3 Maintenance Mode Functions and Operations
3-104
3.6.3 Starting the printer after replacing the print head
This guidance is displayed when starting the printer after executing the print head replacement
operation and replacing the print heads.
The printer starts and the carriage moves to the home position.
(A special initializing operation is performed.)
Move the cursor with the Right and Left buttons, and toggle a digit with the Up and Down
buttons.
A digit that has been toggled disappears.
Finish the selection and press the OK button.
The OK button operation is disabled if incorrect print head combination is selected.
Note
To prevent unnecessary pump operation and ink waste, do not select numbers of print heads that
have not been replaced.
Check that a waste ink bottle is installed and press the OK button.
Install the ink suction tool and press the OK button.
Press the OK button.
Press the OK button and open the ink box cover.
START PRIMING PH?
OK? ◎
INSTALL XXXXXXX
INK SUCTION TOOL ◎
>>REPLACE PRINT HEAD
BOTTLE IS EMPTY? ◎
REPLACE PRINT HEAD
 PRINT HEAD : 1 3 ◎
REPLACE PRINT HEAD
 PRINT HEAD : 1234567 ◎
INITIALIZING...
PLEASE WAIT