Oki IP-6620 - 5.4.15 The subscription expiration date is close; 5.4.16 The amount of ink that can be used is low. (LCIS model)

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
5-61
5.4.15 The subscription expiration date is close
<Description>
The subscription code will expire within one week.
The printer cannot be used anymore after the subscription has expired so we recommend
obtaining a new code when this message appears. The new code can be entered before or after
the expiration date of the previous one.
<Action>
Enter a new subscription code.
Press any button.
5.4.16 The amount of ink that can be used is low. (LCIS model)
<Description>
The amount of ink that can be used reached 0.5 l.
If the ink that can be used runs out, the printer will not be able to print for short period of time.
Therefore, when this message is displayed, prepare a new ink bottle and read the ink amount
extension chip attached to the ink bottle using the printer.
The new ink amount extension chip can be read before or after the available ink runs out.
<Action>
Read a new ink amount extension chip with the printer.
Press any button.
If the warning does not disappears, check the Items to be Checked on the table below, and
perform the actions starting from the top.
No
Items to be Checked
Action
1
Firmware
Upgrade the firmware to the latest version.
2
EEPROM
Replace the EEPROM (see 5.9.2).
3
PCB-ASSY-IPB5-100
Replace the PCB-ASSY-IPB5-100.
AVAILABLE INK IS
RUNNING OUT
SUBSCRIPTION LIMIT
2012/09/30