Oki IP-6620 - 5.5.5 System Error 1310: FPGA(PTG) Load Error

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
5-82
5.5.5 System Error 1310: FPGA(PTG) Load Error
<Description>
Failed to write config from the flash ROM on the PCB-ASSY-IPB5-100 to the ASIC on the
PCB-ASSY-HCB1M.
<Faulty part>
(1) PCB-ASSY-HCB1M
(2) PCB-ASSY-IPB5-100
(3) Carriage cable (FFC): CARRIAGE FFC, MW
(4) Robot cable: ROBOT CABLE, MW
<Action>
Restart the printer.
If the error persists, check the Items to be Checked on the table below, and perform the actions
starting from the top until the problem is solved.
Note:
For this error, be sure to perform the items 1 to 5.
No
Items to be Checked
Action
1
Firmware
Upgrade the firmware to the latest version.
2
The width of the V-shaped folded
part on the
PCB-ASSY-HCB1M-side FFC
Check that the width of the V-shaped folded part on the FFC
is proper. If not, adjust it. For the adjustment procedure, see
6.8.4 PCB-ASSY-HCB1M.
3
FFC’s external damage
Check the following to ensure that the FFC is not damaged.
- FFC’s terminal is detached from its base.
- FFC’s edges have not been abraded by friction.
If the FFC is damaged, replace it.
4
FFC’s connector connection
Reconnect the FFC on both the PCB-ASSY-HCB1M side and
the PCB-ASSY-IPB5-100 side.
If the cable terminals are smeared, softly wipe them with a
soft cloth or lint-free paper dampened with ethanol before
connecting them.
5
Robot cable’s connector
connection
Reconnect the robot cable on both the PCB-ASSY-HCB1M
side and PCB-ASSY-ACT3 side.
Before connecting, check that the connector terminals and
cable connection part are not disconnected. If a connection
failure is found, replace the robot cable.
6
PCB-ASSY-HCB1M
Replace the PCB-ASSY-HCB1M.
7
PCB-ASSY-IPB5-100
Replace the PCB-ASSY-IPB5-100.
8
FFC
Replace all four FFCs.
9
Robot cable
Replace the robot cable.