Oki IP-6620 - 5.5.26 System Error 2100: EEPROM I;O Error; 5.5.27 System Error 2200: Data Path Time-out

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
5-107
5.5.26 System Error 2100: EEPROM I/O Error
<Description>
Could not read or write normally the EEPROM on the PCB-ASSY-IPB5-100.
<Faulty part>
(1) IC(EEPROM）
(2) PCB-ASSY-IPB5-100
<Action>
Restart the printer.
Check the Items to be Checked on the table below, and perform the actions starting from the top
until the problem is solved.
No
Items to be Checked
Action
1
EEPROM installation condition
Remove the EEPROM from the socket, check that its pins are
not bent nor damaged, then set the EEPROM back to the
original position so that its direction is the same as the
original.
2
EEPROM
Replace the EEPROM (see 5.9.2).
3
PCB-ASSY-IPB5-100
Replace the PCB-ASSY-IPB5-100.
5.5.27 System Error 2200: Data Path Time-out
<Description>
Block clear processing in the band memory has not finished.
<Faulty part>
PCB-ASSY-IPB5-100
<Action>
Restart the printer.
Check the Items to be Checked on the table below, and perform the actions starting from the top
until the problem is solved.
No
Items to be Checked
Action
1
Firmware
Upgrade the firmware to the latest version.
2
PCB-ASSY-IPB5-100
Replace the PCB-ASSY-IPB5-100.