OKI Data Infotech Corporation CONFIDENTIAL
Chapter 2 Inspection and Maintenance
2-6
2.6 Platen Cleaning
Use the following procedure to clean the platen if
- vinyl chloride adhesive gets on the platen; or
- ink drops on the platen.
(The procedure to clean ink stains is explained below.)
1. Open the front cover and put a soft cloth
onto ink stains on the platen to soak
them up.
Be careful not to spread the ink on the
platen.
2. Wipe off the ink marks on the platen with
a soft cloth moistened with alcohol.
3. If ink enters vacuum holes on the platen,
clean the holes with a commercially
available cotton swab, and then wipe
clean with a cotton swab moistened with
alcohol.
* Use a cotton swab of 3 mm in diameter.
Soft cloth moistened with alcohol
To Next Page
Loading...
