Oki IP-6620 - Page 380

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 6 Parts Replacement (Disassembly/Reassembly)
6-51
4. Remove the boards.
- PCB-ASSY-IPB5-100 located on the
cover side and 11 fixing screws; and
- PCB-ASSY-ACT3 located on the
printer side and 9 fixing screws.
Note
Do not forget to remove the two screws of the
USB connectors located on the side face of
the PCB-ASSY-IPB5-100.
Note for installation
Be careful not to catch the wires and the
metal plates between the boards when
closing the EL-COVER-MW.
5. Remove the EEPROM from the
PCB-ASSY-IPB5-100 board.
See 5.9.2 IC(EEPROM) for the detailed
procedure.
<Assembly>
Before installing the new PCB-ASSY-IPB5-100 board to the printer, set the EEPROM removed
from the old board to the new one.
Note
The new PCB-ASSY-IPB5-100 does not include an EEPROM. Carefully handle the EEPROM
removed from the old board and be sure to set it to the new board.
PCB-ASSY-ACT3
USB screws
PCB-ASSY-IPB5-100
EEPROM