Oki IP-6620 - Page 501

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 7 Adjustment
7-26
<Post procedure operation>
1. Install the cap cover.
Clean the wiper sponge, the metal plates,
and other parts.
<Note>
Follow the procedure below to check or enter a single color adjustment value.
(Display at the end of the single color adjustment.)
1. Press the CANCEL button.
2. With the Up and Down buttons, select 1
COLOR ADJ VAL, then press the OK
button.
3. With the Up and Down buttons, select a
single color adjustment value.
>>WIPER POS ADJUST
 1 COLOR ADJ VAL ◎
>>>ADJUST FOR 1 COLOR
 Lc ◎
>>WIPING POS ADJUST
 ADJUST FOR 1 COLOR ◎
>>>1 COLOR ADJ VAL
 CC:±XX ◎