OKI Data Infotech Corporation CONFIDENTIAL
Chapter 7 Adjustment
7-45
5. Check the linear encoder vertical
position in both home and maintenance
area positions. Adjust the vertical
position if not correct.
[Vertical adjustment]
1. Move the carriage manually to the
maintenance area.
2. Loosen the two screws securing the
REGISTRATION-ENCODER, and adjust
the position by moving the
REGISTRATION-ENCODER up and
down.
Adjust the linear encoder position so that
the T fence upper edge matches the
linear encoder corner.
(1) If the linear encoder is too high, lower the
REGISTRATION-ENCODER.
To Next Page
Loading...
