Olivetti d-Color MF201 Service Manual

Field Service Ver. 1.0 Jun. 2008 8. Utility Mode
135
Adjustment / Setting
8.6.11 Network Settings
A. Basic Settings
NOTE
• When the settings are changed, turn off the main power switch and turn it on again
more than 10 seconds after.
(1) DHCP
(2) IP Address
• This setting is available only when the following setting is in “IP Input” :
[Admin.] o [Network Settings] o [Basic Settings] o [DHCP].
(3) Subnet Mask
• This setting is available only when the following setting is in “IP Input” :
[Admin.] o [Network Settings] o [Basic Settings] o [DHCP].
(4) Gateway
• This setting is available only when the following setting is in “IP Input” :
[Admin.] o [Network Settings] o [Basic Settings] o [DHCP].
(5) Network Board Set
Functions
• To set whether to automatically acquire IP address or not by DHCP function.
Use
Setting/
Procedure
• The default setting is Auto Input.
“Auto Input” IP Input
Functions • To set the IP address of this machine.
Use • Used to enter IP address when IP address is not automatically acquired by DHCP.
Setting/
Procedure
1. Touch [Network Settings] o [Basic Settings] o [IP Address].
2. Enter the IP address using the 10-key pad.
Functions
• To set the subnet mask of this machine.
Use
Setting/
Procedure
1. Touch [Network Settings] o [Basic Settings] o [Subnet Mask].
2. Enter the subnet mask using the 10-key pad.
Functions
• To set the gateway address.
Use
Setting/
Procedure
1. Touch [Network Settings] o [Basic Settings] o [Gateway].
2. Enter the gateway address using the 10-key pad.
Functions • To set the network board and to display the current operating status.
Use • To change the network board setting to suit the network environment.
Setting/
Procedure
• The default setting is Auto.
“Auto” 100M-Full 100M-Half 10M-Full 10M-Half
d-Color MF201
Y109660-1 Sevice Manual
d-Color MF201

Olivetti d-Color MF201 Specifications

General

Brand	Olivetti
Model	d-Color MF201
Category	All in One Printer
Language	English