10. Service Mode Field Service Ver. 1.0 Jun. 2008
170
Adjustment / Setting
10.5.3 Serial Number
10.5.4 No Sleep
10.5.5 Foolscap Size Setting
10.5.6 Install Date
Functions • To register the serial numbers of the machine and options.
• The numbers will be printed on the list output.
Use • Upon setup.
NOTE
• When main power switch was turned ON while the serial No. was not entered,
the message to require entering the serial No. will be displayed.
• Do not change the serial number registered in the machine. If memory data is
lost and entering the serial number is required, enter the original correct serial
number.
Be careful to enter the correct serial number since characters other than
alphanumeric can be also entered.
Setting/
Procedure
• Type the serial numbers.
Printer, ADF, LCT, Printout Opt, Duplex, Option Tray, Bypass Tray
Functions • To display the option of “OFF” for the sleep mode setting screen available from
Admin. setting.
Use • To display the option of “OFF” for the sleep mode setting.
Setting/
Procedure
• The default setting is “Restrict.”
Allow “Restrict”
Functions • To set the size for foolscap paper.
Use • Upon setup.
• To change the size for foolscap paper.
Setting/
Procedure
• Select the size from among the following five.
220 x 330 mm 8
1
/
2
x 13 8
1
/
4
x 13 8
1
/
8
x 13
1
/
4
8 x 13
Functions • To register the date the main body was installed.
Use • Upon setup.
Setting/
Procedure
1. Call the Service Mode on the screen.
2. Touch [System Input] o [Install Date].
3. Enter the date (Year 4 digit, Month 2 digit, Day 2 digit) from the 10-key pad.
4. Touch [OK] to set the date of installation.
d-Color MF201
Service Manual Y109660-1
d-Color MF201
To Next Page
Loading...
Need help?
General
