8. Utility Mode Field Service Ver. 1.0 Jun. 2008
124
Adjustment / Setting
8.4 User Management
8.4.1 Confirmation Beep
8.4.2 Alarm Volume
8.4.3 Line Monitor Sound
See P.15 of the FK-507 service manual.
8.4.4 Job Complete Beep
8.4.5 Panel Cleaning
8.4.6 Dehumidify
• It is not displayed when bit1 for the mode 478 is set to “0” by the following setting:
[Service Mode] o [System] o [Software Switch Setting].
Functions • To set the sound when pressing the key on the control panel.
Use • To change the volume of the key sound or to make no sound.
Setting/
Procedure
• The default setting is 3.
0 to 5
Functions • To set the volume of the sound when alarm occurs or when the key operation is pro-
hibited.
Use • To change the volume of the alarm or to make no sound.
Setting/
Procedure
• The default setting is 3.
0 to 5
Functions • To set the volume of the beep when the job is complete.
Use • To change the volume of the beep for complete or to make no sound.
Setting/
Procedure
• The default setting is 3.
0 to 5
Functions • To temporarily invalid the key operation on the panel when cleaning the control panel.
Enlarge Display key will stay valid.
Use • To clean the control panel.
Setting/
Procedure
• Pressing [Reset] key cancels the panel cleaning screen.
Functions • To turn on the scanner exposure lamp for the set period of time (five minutes) to
dehumidify the scanner.
Use • To keep the image quality even when the scanner builds up condensation due to
rapid temperature change or high humidity.
Setting/
Procedure
• Pressing [Dehumidify] button turns on the scanner exposure lamp to start dehumidi-
fying.
d-Color MF201
Service Manual Y109660-1
d-Color MF201
To Next Page
Loading...
