Olivetti d-Color MF201 - Counter; Life; Procedure

Field Service Ver. 1.0 Jun. 2008 10. Service Mode
253
Adjustment / Setting
10.6 Counter
• The counter displays the counts of various counters to allow the technical representative
to check or set as necessary.
10.6.1 Procedure
A. Checking the counter
1. Call the Service Mode to the screen.
2. Touch [Counter].
3. Touch [Check], and touch the key of the counter to be checked.
B. Clearing the individual counter
1. Call the Service Mode to the screen.
2. Touch [Counter].
3. Touch [Counter Reset], and select the key for the counter to be cleared.
4. Touch [Execute] to clear the counter value.
C. Collectively clearing the counter
1. Call the Service Mode to the screen.
2. Touch [Counter].
3. Select the key for the counter to be cleared, and press the Clear key.
When clearing by mistake, press the interrupt key to recover.
10.6.2 Life
Functions • To check the number of hours or times each of the different maintenance parts has
been used.
• To clear the count of each counter.
Use • When each of the maintenance parts is replaced.
Setting/
Procedure
• If a counter is cleared mistakenly, press the Interrupt key, which will undo the clearing
operation.
• It is not possible to clear the count of the counters for the transfer belt unit and imag-
ing unit, which are provided with a new unit detection function.
<1/3>
• Fusing Unit : Number of times a sheet of paper is fed through
• Transfer Unit : Number of times a sheet of paper is fed through
• Tray 1 : Number of sheets of paper fed from tray 1
• Tray 2 : Number of sheets of paper fed from tray 2
• Tray 3 : Number of sheets of paper fed from tray 3
• Tray 4 : Number of sheets of paper fed from tray 4
• Bypass Tray : Number of sheets of paper fed from the bypass
<2/3>
• Imaging Unit (C) : Period of time over which the cyan imaging unit has been used.
• Imaging Unit (M) : Period of time over which the magenta imaging unit has been
used.
• Imaging Unit (Y) : Period of time over which the yellow imaging unit has been used.
• Imaging Unit (K) : Period of time over which the black imaging unit has been used.
• LCT Parts : Number of sheets of paper fed from the LCT
• ADF Feed : Number of sheets of paper fed through the take-up section of the ADF
• ADF Reverse : Number of sheets of paper fed through the turnover unit of the ADF
<3/3>
• Printout Opt : Number of times a sheet of paper is fed through
d-Color MF201
Y109660-1 Sevice Manual
d-Color MF201