Quantum Superloader 3 - Page 107

Chapter 4 SuperLoader Operation
Front Panel Functionality
SuperLoader User’s Guide 81
To Eject a Cartridge by Bar Code: 4
1 On the main menu, scroll to
Commands, then press Enter.
2 On the Commands submenu, scroll to
Eject, then press Enter.
3 On the Eject submenu, scroll to
Cartridge, then press Enter.
4 Scroll to
By Barcode. A bar code label appears.
5 Scroll to the label that corresponds to the cartridge you want to eject.
Press
Enter. An hourglass appears on the LCD as the cartridge you
want is ejected from the mailslot. Wait until the hourglass disappears
from the LCD before pulling out the cartridge.
To Eject a Cartridge by Location: 4
1 On the main menu, scroll to
Commands, then press Enter.
2 On the Commands submenu, scroll to
Eject, then press Enter.
3 On the Eject submenu, scroll to
Cartridge, then press Enter.
4 Scroll to
By Location. A map of all the magazine slots appears. Slots
that are occupied by a data cartridge are indicated by an asterisk (
*).
The slot that is occupied by a cleaning tape is indicated with an
ampersand (
@), if AutoClean is enabled. Scroll to the slot containing
the cartridge you want to eject.
5 Press
Enter. An hourglass appears on the LCD as the cartridge you
want is ejected from the mailslot. Wait until the hourglass disappears
from the LCD before pulling out the cartridge.
To Eject a Cartridge from the Tape Drive: 4
1 On the main menu, scroll to
Command, then press Enter.
2 On the Commands submenu, scroll to
Eject, then press Enter.
3 On the Eject submenu, scroll to
Cartridge, then press Enter.
4 Scroll to
From Drive, then press Enter. An hourglass appears on the
LCD as the cartridge you want is ejected from the mailslot. Wait until
the hourglass disappears from the LCD before pulling out the
cartridge.