Rohde & Schwarz R&S FSL3 - Page 1085

SENSe Subsystem (Analog Demodulation, K7) R&S FSL
1300.2519.12 6.326 E-11
[SENSe<1|2>:]FILTer:LPASs:FREQuency[:ABSolute]
This command selects the absolute low pass filter type. For details on filters refer to chapter
"Instrument Functions", section "Analog Demodulation (Option K7)", Low Pass AF Filter
softkey.
The numeric suffixes <1|2> are irrelevant.
Parameter
3kHz | 15kHz | 150kHz
Example
FILT:LPAS:FREQ 150kHz
Selects the low pass filter for the demodulation bandwidth range from 400 kHz to 16 MHz.
Characteristics
RST value: 15kHz
SCPI: device–specific
Mode
ADEMOD
[SENSe<1|2>:]FILTer:LPASs:FREQuency:RELative
This command selects the relative low pass filter type. For details on filters refer to chapter
"Instrument Functions", section "Analog Demodulation (Option K7)", Low Pass AF Filter
softkey.
The numeric suffixes <1|2> are irrelevant.
Parameter
5PCT | 10PCT | 25PCT
Example
FILT:LPAS:FREQ 25PCT
Selects the low pass filter as 25% of the demodulation bandwidth.
Characteristics
RST value: 25PCT
SCPI: device–specific
Mode
ADEMOD