Rohde & Schwarz R&S FSL3 - Page 1086

R&S FSL SENSe Subsystem (Analog Demodulation, K7)
1300.2519.12 6.327 E-11
SENSe:FREQuency Subsystem (Analog Demodulation, K7)
The SENSe:FREQuency subsystem defines the frequency axis of the active display. The frequency
axis can either be defined via the start/stop frequency or via the center frequency and span.
Commands of the SENSe:FREQuency Subsystem
– [SENSe<1|2>:]FREQuency:CENTer:STEP:LINK
[SENSe<1|2>:]FREQuency:CENTer:STEP:LINK
Parameter
SPAN coupling to frequency display range (for RF spectrum result display)
RBW coupling to demodulation bandwidth (for all result displays except RF spectrum)
OFF manual input, no coupling
For further details refer to "[SENSe<1|2>:]FREQuency:CENTer:STEP:LINK" on page 6.201.
SENSe:SWEep Subsystem (Analog Demodulation, K7)
The SENSe:SWEep subsystem controls the sweep parameters.
Commands of the SENSe:SWEep Subsystem
– [SENSe<1|2>:]SWEep:TIME
[SENSe<1|2>:]SWEep:TIME
Parameter
Refer to chapter "Instrument Functions", section "Analog Demodulation (Option K7)" – "Sample
rate, measurement time and trigger offset".
For further details refer to "[SENSe<1|2>:]SWEep:TIME" on page 6.234.