Rohde & Schwarz R&S FSL3 - Page 1099

CALCulate:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.340 E-11
CALCulate<1|2>:BTOoth:CFSTability:FERRor:BLOCk?
This command reads the maximum frequency deviation of all blocks in the Carrier Frequency
Stability and Modulation Accuracy measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see CONFigure:BTOoth:MEASurement command). With all
other measurements this command will lead to a query error.
Parameter
MINimum | MAXimum | AVERage
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS CFST
Activates the Carrier Frequency Stability and Modulation Accuracy measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFST:FERR:BLOC? AVER
Reads the maximum average frequency deviation of all blocks.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:CFSTability:FERRor:INITial?
This command reads the combined frequency deviation of all packets and all blocks in the
Carrier Frequency Stability and Modulation Accuracy measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see CONFigure:BTOoth:MEASurement command). With all
other measurements this command will lead to a query error.
Parameter
MINimum | MAXimum | AVERage
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS CFST
Activates the Carrier Frequency Stability and Modulation Accuracy measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFST:FERR:INIT? MAX
Reads the combined maximum frequency deviation of all packets and all blocks.