R&S FSL CALCulate:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.341 E-11
C
haracteristics
RST value: –
SCPI: device–specific
M
ode
BT
CALCulate<1|2>:BTOoth:DPENcoding:[TOTal]?
This command reads the number of tested packets in the Differential Phase Encoding
measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Differential Phase Encoding measurement
(see CONFigure:BTOoth:MEASurement command). With all other measurements
this command will lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS DPEN
Activates the Differential Phase Encoding measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:DPEN?
Reads the number of tested packets.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:DPENcoding:BER?
This command reads the bit error rate (BER) in the Differential Phase Encoding measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Differential Phase Encoding measurement
(see CONFigure:BTOoth:MEASurement command). With all other measurements
this command will lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS DPEN
Activates the Differential Phase Encoding measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:DPEN:BER?
Reads the bit error rate.
To Next Page
Loading...
