Rohde & Schwarz R&S FSL3

To Next Page

To Previous Page

CALCulate:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL

1300.2519.12 6.346 E-11

INIT:IMM;*WAI

Starts the measurement with synchronization and erase previous measurement results.

CALC:BTO:MCH:DF1:AVER? MIN

Queries minimum value "11110000".

Characteristics

RST value: –

SCPI: device–specific

Mode

CALCulate<1|2>:BTOoth:MCHar:DF<1|2>:MAXimum?

This command determines the maximum frequency deviation for different bit patterns of the

payload. The suffixes of DF<1|2> assign the frequency deviation and the bit pattern as follows:

Frequency

deviation

f1max f2max

Bit pattern "11110000" "10101010"

The numeric suffixes <1|2> of CALCulate are irrelevant for this command.

Note: This command is only available with active Modulation Characteristics measurement

(see CONFigure:BTOoth:MEASurement command). With all other measurements

this command will lead to a query error.

Parameter

MINimum | MAXimum | AVERage

Example

For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on

page 6.334.

CONF:BTO:MEAS MCH

Activates the Modulation Characteristics measurement.

CONF:BTO:SWE:COUN 20

Initiates the sweep counter with 20.

... EUT emits bit pattern 1111000