Rohde & Schwarz R&S FSL3 - Page 1106

R&S FSL CALCulate:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.347 E-11
C
ALCulate<1|2>:BTOoth:MCHar:DF2:PERCent?
This command determines the percentage of measurements of the frequency deviation, for
which the value of f2
max
is within the allowed range. Therefore only the numeric suffix 2 is
allowed for DF.
The numeric suffixes <1|2> of CALCulate are irrelevant for this command.
Note: This command is only available with active Modulation Characteristics measurement
(see CONFigure:BTOoth:MEASurement command). With all other measurements
this command will lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS MCH
Activates the Modulation Characteristics measurement.
CONF:BTO:SWE:COUN 20
Initiates the sweep counter with 20.
... EUT emits bit pattern 10101010
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:MCH:DF2:PERC?
Queries the percentage of "in range" measurements.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:MCHar:RATio?
This command determines the ratio of the average frequency deviations for varying bit patterns
of the payload.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Modulation Characteristics measurement
(see CONFigure:BTOoth:MEASurement command). With all other measurements
this command will lead to a query error.
Parameter
MINimum | MAXimum | AVERage
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS MCH
Activates the Modulation Characteristics measurement.
CONF:BTO:SWE:COUN 20
Initiates the sweep counter with 20.
... EUT emits bit pattern 1111000
INIT:IMM;*WAI
Starts the measurement with synchronization and erase previous measurement results.
... EUT emits bit pattern 10101010