CALCulate:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.348 E-11
INIT:CONM;*WAI
Starts additional measurement with synchronization.
CALC:BTO:MCH:RAT? MIN
Queries the minimum value.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:OPOWer[:PEAK]?
This command reads the peak value of the Output Power measurement according to the
BLUETOOTH standard.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Output Power measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements it will
lead to a query error.
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:OPOW?
Queries the output power result.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:OPOWer:AVERage?
This command reads the average value of the Output Power measurement according to the
Bluetooth standard.
With a sweep count value of 1 (CONFigure:BTOoth:SWEep:COUNt) and trace mode
clear/write (DISPlay[:WINDow<1|2>]:TRACe<1...6>:MODE) the selected number of
measurements is performed when a single sweep is started
(INITiate<1|2>[:IMMediate]). During these measurements the minimum and maximum
values are determined. If only a single measurement is performed, the minimum and maximum
value will be identical.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Output Power measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements it will
lead to a query error.
To Next Page
Loading...
