R&S FSL CALCulate:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.349 E-11
Parameter
MINimum | MAXimum | AVERage
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
p
age 6.334.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:SWE:COUN 20
Activates measurement over 20 sweeps.
INIT;*WAI
Activates measurement over 20 sweeps.
CALC:BTO:OPOW:AVER? MAX
Queries the maximum average value of the Output Power measurement.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:PLENgth?
This command reads the length of the packet analyzed by the preceding measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available, if a measurement was started via
INITiate<1|2>[:IMMediate] before and if this measurement is completed. With a
missing or incomplete measurement the command will cause a query error.
This command is only available with the measurements Output Power, Modulation
Characteristics, Initial Carrier Frequency Tolerance, and Carrier Frequency Drift (see
CONFigure:BTOoth:MEASurement command).
Example
INST:SEL BTO
Activates the Bluetooth Measurements option
INIT:CONT OFF
Selects single sweep operation
CONF:BTO:MEAS OPOW
Activates the Output Power measurement
INIT;*WAI
Starts the measurement with synchronization
CALC:BTO:PLEN?
Queries the packet length
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
To Next Page
Loading...
