Rohde & Schwarz R&S FSL3 - Page 1109

CALCulate:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.350 E-11
CALCulate<1|2>:BTOoth:PTYPe?
This command determines the type of the packet analyzed by a preceding measurement.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available, if a measurement was started via
INITiate<1|2>[:IMMediate] before and if this measurement is completed. With a
missing or incomplete measurement the command will cause a query error.
This command is only available with the measurements Output Power, Modulation
Characteristics, Initial Carrier Frequency Tolerance, and Carrier Frequency Drift (see
CONFigure:BTOoth:MEASurement command).
Response
The following packet types are recognized and returns as character data: AUX1, DH1, DH3,
DH5, DM1, DM3, DM5, FHS, HV1, HV2, HV3, DV, NULL, POLL, UNDEF
Example
INST:SEL BTO
Activates the Bluetooth Measurements option
INIT:CONT OFF
Selects single sweep operation
CONF:BTO:MEAS OPOW
Activates the Output Power measurement
INIT;*WAI
Starts the measurement with synchronization
CALC:BTO:PTYP?
Queries the packet type
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:RTPower:[DPSK]?
This command reads the average transmission power for the DPSK sections of the packet in
the Relative Transmission Power measurement. With a sweep count

1, the command returns
the current value, irrespective of the parameter.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Relative Transmit Power measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements this
command will lead to a query error.
Parameter
MINimum | MAXimum | AVERage
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS RTP
Activates the Relative Transmit Power measurement.
CONF:BTO:SWE:COUN 10
Initiates the sweep counter with 10.