R&S FSL CALCulate:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.351 E-11
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:RTP? MIN
Reads the lowest recorded average power of the DPSK section of all packets.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:RTPower:GFSK?
This command reads the transmission power for the GFSK sections of the packet in the
Relative Transmission Power measurement. With a sweep count
1, the command returns the
current value, irrespective of the parameter.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Relative Transmit Power measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements this
command will lead to a query error.
Parameter
MINimum | MAXimum | AVERage
Example
For the first steps refer to "Example: Adapting the settings to the characteristics of the DUT" on
page 6.334.
CONF:BTO:MEAS RTP
Activates the Relative Transmit Power measurement.
CONF:BTO:SWE:COUN 10
Initiates the sweep counter with 10.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:RTP:GFSK? MIN
Reads the highest recorded average power of the GFSK section of all packets.
Characteristics
RST value: –
SCPI: device–specific
Mode
BT
CALCulate<1|2>:BTOoth:RTPower:RATio?
This command reads the ratio of the transmission power for the GFSK and DPSK modulation in
the Relative Transmission Power measurement (P
DPSK
/P
GFSK
). With a sweep count
1, the
command returns the current value, irrespective of the parameter.
The numeric suffixes <1|2> are irrelevant for this command.
Note: This command is only available with active Relative Transmit Power measurement (see
CONFigure:BTOoth:MEASurement command). With all other measurements this
command will lead to a query error.
To Next Page
Loading...
